Our experience has been built up on a cross section of different OEM machinery. We can service your breakdowns whether it is alignment, timing, gearbox or just general wear or a breakage. We can provide this service irrespective of machinery origin, age or size with minimal downtime.

Factory overhaul - xtrutech offer a partial or full overhaul and rebuild service. We have a fully equipped refurbishing workshop based in Stoke- on-Trent, Staffordshire. Refurbishing and up-grading an older extruder can be a cost-effective alternative to buying a new one.

Gearboxes for co-rotating Twin screw extruders require specialist knowledge. We can service or repair all major makes of gearbox including Flender, PIV and Hygate.

Our service Engineers have many years of experience on most makes of twin screw extruder from older Baker Perkins and W&P units to more modern APV, Coperian, Leistritz, Maris units and many more
 

Preventive maintenance contracts from xtrutech can help to avoid downtime through regular on-site machine inspections and planned maintenance routines. Our special rates make this a real alternative. We can assist you to develop your machine so that it becomes more reliable and less prone to breakdown.

Having trouble removing screw elements? - Why not send your shafts to xtrutech and let our experienced service engineers clean, strip and re-configure your screw elements with a fast and efficient turnaround. We will check your existing element for signs of cracking and severe wear and replace only as necessary.