Size 2
Drum Cooler
Rapid cooling, easy clean compact design, low cost replaceable belt and a Mini-breaker as standard. The Xtrutech Drum Coolers are designed to match the outputs from our XTS Twin Screw Extruders.
Xtrutech drum coolers and conveyors feature energy efficient cooling, whilst also being environmentally friendly, with a compact design and flaker unit as standard.
Size 1: Bench top for lab samples
Size 2: R&D and / or small batch production up to 150 KGs/hr
Size 3: Small batch production up to 350 Kgs/hr
Size 4: up to 800 Kgs/hr
Size 5: up to 1,400 Kgs/hr
View next model
Rapid cooling of thermosetting product
Product spread evenly over drum width to improve product cooling efficiency
Energy efficient cooling with reduced water usage and reduced air moisture in contact with end product
Compact design / reduce length
Mini breaker / flaker unit as standard
Low cost / easy to change synthetic endless belt
Environmentally friendly
Reduced moisture content in end product
Space saving
Features
- Rapid cooling of thermosetting product
- Product spread evenly over drum width to improve product cooling efficiency
- Energy efficient cooling with reduced water usage and reduced air moisture in contact with end product
- Compact design / reduce length
- Mini breaker / flaker unit as standard
- Low cost / easy to change synthetic endless belt
- Environmentally friendly
- Reduced moisture content in end product
- Space saving
SELECT MODEL
The internal structure within XTS Drum Coolers allows the molten product to pass through multiple cooling zones, resulting in evenly applied temperature reduction, without compromising the integrity of the product. Our water-cooling technique is both cost and energy efficient and in turn promotes the reduction of air moisture, prioritising both sustainability and quality.
Our designs are compact and yet even our smaller production sizes are capable of intense yields of 350 kgs/per hour. The endless belt is easy to maintain and replace accordingly, supporting the continuation of production. Also included is a mini breaker/ flaker as standard, promoting concise particle size distribution of ≤ 4mm to improve grinding efficiency, complete with removable combes and breaker rotor, that is hinged for accessible maintenance.
Our Drum Coolers are designed for seamless integration with XTS Extruders.
- Fully guarded to comply with European Machinery Directive 2006/42/EC
- Operator control cabinet complete with drives and safety circuit to IP55
- The Drum Cooler unit is located on guide rails so it can be moved away from the extruder via a motor drive system
- The Drum Cooler is shipped fully assembled ready to be connected to customer utilities
| Product throughput | Max 800 Kgs/hr Ave: 500kgs/hr |
| Supply voltages | 380 to 480 V, 50 or 60 Hz |
| Signal voltage | (internally) 24 V |
| Chilled water flow rate (supplied by customer) | 320 lt/min |
| Required temperature of cooling water: | 8 -10° C |
| Required cooling water pressure | min. 3-4 bar |
| Water Connections | 2” BSP |
| Product Inlet Temp | <= 150°C |
| Product/Flake Temp | < 25°C |
| Drum Coolers | ||||||
| To match extruder | XTS19 | XTS24 | XTS35 | XTS44 | XTS56 | |
| Size | 1 | 2 Lite | 2 | 3 | 4 | 5 |
| Output Kgs/hr max | 25 | 100 | 150 | 350 | 800 | 1400 |
| Drum cooler size (nominal) | 150 | 300 | 300 | 600 x 700 | 800 x 1000 | 1.300 x 1000 |
